A friend will print the book and envelope to a printing house theory, the reason is that the production of the book cover cutting are missing the phenomenon of white edges. At that time, the friend was very angry, and the printer felt that he was very wronged, because they had been very careful when cutting, the main reason was that the friend did not know how to reserve the bleeding position when designing, and the printing company did not do its duty to remind the department of the need to reprint the situation.

polyester sublimation paper factory What is the bleeding position?

Album printing and other printed matter after printing, there will always be how many irregular edges, these must be cut off, so in the design time should be reserved for a certain width, this is the bleeding position, the Great Wall printing suggested that designers in the design of printed matter, Try to leave 3mm outside the finished product size (some special cases may want to leave more) You can also directly consult the Great Wall printing customer service, of course, under normal circumstances when we receive the customer's document, will carefully check. When you encounter a document that does not leave a bleeding spot, it will remind you, or assist the customer to correct the document. In addition, the advantages of setting the bleeding position are also manifested in: 1. Reduce the difficulty of post-printing processing, such as cutting

Industry, big plate work, etc. 2. For cross-page printed matter, the integrity of the printed picture can be achieved.

Of course, different prints have different requirements for bleeding sites, and it is not always possible to leave more bleeding sites and reduce the size of the finished product. For example, for single-sheet printing, posters, due to each

All four sides of the page have to be cut, so all four sides have to be set to bleed. For example, every 2 pages of corporate picture albums and magazines are a piece of paper, and the binding line is located in the middle of each paper

On the side where the stitching is located, do not set the bleeding, just set it on the other 3 sides. If you still have questions about the bleeding position, contact the Great Wall printing customer service, we directly answer for you can make it easier for you to understand

polyester sublimation paper factory https://www.suzhoulongterm.com/500m-Dye-sublimation-transfer-paper.html